Specification Sheet

9591
Phenolic Bariatric Shower Seat
© 2018 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539) [phone]
bradleycorp.com
Orders composed of products indicated as Bradex
®
will be available to ship in three days after receipt of
order at the factory. There is no pricing penalty for
this service from Bradley.
Page 1 of 1 4/30/2018
This information is subject to change without notice.
Bradley_ShowerSeat_9591
ADA Compliant
Color – White Bradex
®
Product Materials
FRAME: satin finish stainless steel, 1½" HDPE support bar and 18 gauge
1" diameter tubing.
MOUNTING FLANGES: 7 gauge satin finish stainless steel with three
mounting holes provided in each flange for installation.
LOWER SUPPORT BRACKET: 16 gauge satin finish stainless steel.
SEAT: ½" thick solid phenolic. White matte finish Melamine bonded onto the
phenolic for color. All exposed edges are machined smooth to a uniform dark
finish. Square configuration.
Operation
Hinged seat folds up and out of the way when not in use. When properly
installed, seat can support up to 500 lbs. – static load.
Installation
Verify all rough-in dimensions prior to installation. Provide concealed backing
or anchors as specified by architect before finished wall is applied. Secure to
wall with mounting screws (not included) at holes provided. Locate mounting
holes at appropriate height above finished floor to meet seat height requirement.
Secure lower support bracket to wall at appropriate location. Mounting kit
available from Bradley. For more information, visit bradleycorp.com.
WARNING: Be sure to use reinforced backing
behind wall where mounting screws or anchoring
devices are installed to ensure adequate support for
the shower seat. All anchoring devices (supplied by
installer) must be appropriate for specific wall
construction. Severe personal injury and/or
property damage may result from improper
mounting.
Guide Specification
Folding white phenolic shower seat shall be ½" thick phenolic with Melamine
bonded to its phenolic core. Secured to the frame of 18 gauge, 1" diameter
tubing, and 1½" HDPE support bar. Support leg contained in 16 gauge lower
support bracket. Shower seat must meet or exceed ADA guidelines.
Overall dimensions: 17"W x 15"D x ½" thick.
ADA Compliant
Consult local and national accessibility codes for proper
installation guidelines.
Conformity and compliance to local and national codes is
the responsibility of the installer.
15"
(381mm)
5¼"
(133mm)
2¼"
(57mm)
1
3
⁄8"
(35mm)
5"
(125mm)
17" to 20"
(432mm to 508mm)
4¾"
(121mm)
8½"
(216mm)
17"
(432mm)
27¼" to 30¼"
(692mm to 768mm)
7
⁄8"
(22mm)
1¼"
(32mm)
1¾"
(45mm)
9⁷⁄₈"
(251mm)
10¼"
(260mm)
2½"
(64mm)
15.87"
(403.098mm)
1.13" to 4.13"
(28.702mm to 104.902mm)
Depending on Mounting Height