Owner manual

ManualsBrandsBradley ManualsLightingE19-120A

Installation

Instructions

Bradley Drench

Shower

Horizontal Supply

Model E1

9-120A

Table of Contents

Pre-Installation Information

...............

Installation Instructions

..................

Assembly of Components

.................

PartsList

.............................

IMPORTANT

This equipment should be inspected,

tested, and recorded weekly to maintain

proper operation.

Main water supply to the eye wash

should be “ON” at all times.

This installation manual and parts list

should be filed by the building owner’s

maintenance department.

215-148AE

Ref. G; EN 98-579

Page 1 of 4

PO. Box 309, Menomonee Falls, WI USA 53052-0309

PHONE (414) 251-6000 FAX (414) 251-5617

http:/lwww.bradleycorp.com

Summary of content (4 pages)

PAGE 1
Installation Instructions Bradley Drench Shower - Horizontal Supply Model E19-120A Table of Contents Pre-Installation Information ............... Installation Instructions .................. Assembly of Components ................. PartsList . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 3 4 4 IMPORTANT This equipment should be inspected, tested, and recorded weekly to maintain proper operation. Main water supply to the eye wash should be “ON” at all times.
PAGE 2
Bradley Drench Shower - Horizontal Supply Model No. E19-120A Installation Instructions Pre-Installation Information Operation The drench shower is easily activated by pulling the triangular pull rod downward, and deactivated by pushing the triangular pull rod upward. Components Showerhead: The corrosion-resistant stainless steel showerhead has a 254 mm (10”) diameter. Shower Valve: The 1” IPS stay-open valve is operated by a stainless steel pull rod with a triangle handle.
PAGE 3
Installation Instructions Bradley Drench Shower - Horizontal Supply Model No. E19-120A Installation Instructions Supplies Required: l l l l Pipe sealant Piping to 1” BSP water supply inlet on unit Adequate supply pipe supports Minimum 102 mm (4”) drain to accommodate 115 liters per minute discharge for drench shower waste Step 1: Assemble drench shower I NOTE: Flush the water supply line before beginning installation. 1. Assemble drench shower components as shown in Figure 2 on page 4. 2.
PAGE 4
Bradley Drench Shower - Horizontal Supply Model No. EM-120A Installation Instructions Assembly of Comk3onents i I Figure 2 1” BSP SUPPLY INLET 0 4c IService Parts List ITEM 4 QTY. DESCRIPTION ITEM PART NO. QTY.