Installation manual

Express
®
Deck Lavatory System EXD-Series
EXD-2N Installation
4 3/2/2012 Bradley Corporation • 215-1542 Rev. F; ECN 11-08-011
Installation Instructions
Supplies required for installation:
• (6)3/8”wallanchors,boltsand1”min.O.D.washerstomountmainframeandbowlto
wall(minimumpull-outratingof1,000lbs.)
• STD.HEIGHTONLY:(2)3/8”wallanchors,boltsand1”min.O.D.washerstomount
scuffbasetowall
• 1/2”Nominalcoppertubingforhotandcoldsupplypiping
• 1-1/2”NPTdrainpiping
• 110voltelectricaloutletforoptional110/24VACplug-intransformer,ifrequired
• (2)#10wallanchorsandfastenersforoptionalNavigatorvalvemounting
• 240/208-voltor277-voltelectricalboxforoptionalelectrictanklesswaterheater
Step 1: Rough in
IMPORTANT: Dimensions shown in Figure 1 on page 5 are for a Standard and Wall-
Hung Pedestal Express
®
Deck only. Make sure to follow appropriate
dimensions based on configuration and required rim height. See
Charts 1 and 2 on page 5 before beginning rough-ins.
1.Roughin1/2”nominalcoppertubingforhotandcoldsupplylinesthroughwallat
dimensionsshown.
2.Roughin1-1/2”NPTdrainwasteconnectionthroughwallatdimensionsshown.
3.FOROPTIONALELECTRICFAUCETS:Installthe110voltGFCIelectricaloutletper
localcodeatthelocationshowninFigure1.
4.Installfourtosix3/8”wallanchorswithaminimumpull-outratingof1,000lbs.(supplied
byinstaller)atthelocationsshowninFigure1.
5.Onthebackofthebowl,measurethedistancebetweenthe3/4”bowlmountingholes.
Dividethismeasurementinhalf.Measureandmarkthisdimensiononthewalltothe
leftofthecenterlineandtotherightofthecenterline.Installtwo3/8”wallanchorswitha
minimumpull-outratingof1,000lbs.(suppliedbyinstaller)atthelocationsmarked(ref.
location“A”showninFigure1).
NOTE:
Wall anchors at location “C” (standard frame only) do not require a minimum pull-out
rating of 1,000 lbs.
NOTE: The anchors will be used to mount the Express® Deck bowl and frame to the wall.