Installation manual

Express
®
Deck Lavatory System EXD-Series
Installation EXD-2N
Bradley Corporation • 215-1542 Rev. F; ECN 11-08-011 3/2/2012 7
Figure 4
Installation Instructions continued . . .
Step 3: Installing bowl
WARNING: To prevent serious injury and/or damage to the bowl, move and
position the bowl with the assistance of another person and always
use appropriate lifting procedures.
NOTE: Refer to Figure 4 below when installing the bowl.
1.Withsomeonetoassistyou,placethebowlsquarelyontotheframe.
2.Attachthefrontundersideofthebowltotheframeusingthetwo1/4”-20x1/2”pan-
headscrewsandwashersprovided.Do not tighten bolts at this time.
IMPORTANT: When bolting the bowl to the frame and wall, do not overtighten
bolts. Overtightening bolts can damage the Terreon® material.
3.Afterthebowlisattachedtotheframe,use3/8”boltsand1”min.O.D.washers(supplied
bytheinstaller)toboltthebowltothewallanchors,twoplaces.
4.Tightenthescrewsinstalledinprocedure#2abovetosecurethebowltotheframe.Do
not overtighten.
Bowl
¼"-20ScrewsandWashers
(2)PlacesBowl/Frame
Mounting
Main Frame
3
⁄8" Bolt and Washer
(2)PlacesforBowlMounting
Scuff Base Frame
and Drain Assembly
NotShownForClarity