Installation manual
Express
®
Deck Lavatory System EXD-Series
Installation EXD-2N
Bradley Corporation • 215-1542 Rev. F; ECN 11-08-011 3/2/2012 9
Installation Instructions continued . . .
Step 5: Optional hot water heater
WARNING: To avoid personal injury or damage to the unit when installing the water
heater, make all plumbing connections first, then proceed with the
electrical connections.
Figure 6a
Figure 6b
NOTE: 240/208 or 277 voltage
is required for hot water heater.
Refer to the installation manual
provided with the hot water heater
for further installation information.
1. Remove the cover from the
waterheater.Attachthe
brackettothecoverwith
thetwoscrews,nutsand
washers,thenreattachthe
cover (see Figure 6a).
2.Hangthewaterheateronthe
right side frame member (see
Figure 6b).
3.Connectthe1/2”flexiblehose
fromthecoldwatersupply
stub-outtothehotwater
heater inlet.
4.Connectthe1/2”flexiblehose
fromthehotwaterheater
outlet to the supply inlet on
the solenoid valve assembly.
Step 6: Completing installation
1. Install the faucets according
to the installation instructions
thatcamewithyourfaucets.
2.Turnonthewatersupplyto
theExpress®Deckandcheck
forleaks.
3. FOR DECKS WITH
INFRARED FAUCETS ONLY:
Turnontheelectricalpowerto
the electrical outlet and pass
your hand in front of each
faucet’s sensor until all the air
is purged from the lines and
waterisflowingsmoothly.
Stop Valve
Water
Heater
Inlet
Outlet to
Faucets
Cold Water
Supply
Bracket
#8-32x¾"
Round Head
MachineScrew
Water
Heater
Base
#8Washer
#8Nut
Water Heater
Cover