Installation manual

Installation SS-3N/AST/STD, SS-3N/AST/WH
Bradley Corporation • 215-1494 Rev. E; ECN 07-814 12/11/07 7
SCUFF BASE FRAME
STANDARD HEIGHT
FRAME ONLY
SCUFF PANEL
STANDARD HEIGHT
FRAME ONLY
2
Mount Frame to Wall
3
Install Bowl
Anchoring the frame to a wall that is not
flat may cause the frame to bend, making
it difficult to reinstall the access panels. If
necessary, use shims to compensate for
wall distortion.
A
Using a T20 torx key, remove
the fasteners securing the
access panel to the main
frame, and remove the panel.
The sprayhead body has slotted holes for adjusting
the fit-up with the bowl and wall.
For clarity, the scuff base frame and drain are not
shown. Turn the tailpiece down to its proper position
before installing the bowl.
Secure the bowl to the
wall anchors with 3/8”
bolts and 1” min. O.D.
washers, two places.
Do not overtighten.
B
Attach the bowl to the frame with
1/4”-20 x 1/2” pan-head screws
and washers. Do not tighten.
A
Tighten the pan-head screws
Do not overtighten.
C
Once you have positioned the frame such that it is
level and flat against the wall or shimmed, mount
the frame to the wall at six places using 3/8” bolts
and 1” min. O.D. washers.
NOTE: When mounting the standard height frame,
mount the scuff base to the wall at the same time
using two additional 3/8” bolts and washers.
B