Installation Sheet

ManualsBrandsBradley ManualsBathroom PartitionsBradley Series 400 2 Stall In-Corner Alcove 75" Bradmar Plastic Bathroom Compartments Kit

Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400

Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018

Headrail

Make sure the pilasters are plumb and that the pilaster has been secured to the mounting hardware. Leave the appropriate

door opening between the pilasters as shown on your submittal drawing.

Completed Headrail Assembly

The illustrations on this page show mounting hardware and fasteners for a generic application. Refer to your submittals

to determine your actual headrail conﬁgurations.

Some headrail sections may need to be cut to an appropriate size. Refer to your submittals for general headrail placement.

Headrail conﬁgurations that come to an intersection should meet over pilaster (see completed headrail assembly view below).

Wall

Place headrail over the top of each pilaster

located at the wall and slide it tight against the

side wall. Mark the outline of the headrail on the

wall and remove the headrail.

Place the headrail bracket on

the outline marked on the wall

and mark the locations of the

mounting holes. Remove bracket

and drill (2) Ø5/16" holes a

minimum of 2" [51 mm] deep.

Prior to securing to the wall,

enlarge the (2) back mounting

holes of the bracket to Ø1/4".

Secure the bracket to the wall

with the #14 x 2" screws and

plastic anchors provided.

Place headrail over the top of the pilasters and

slide it tight into the mounting bracket. Use the

mounting bracket as a template and drill a Ø7/32"

hole through the headrail. Secure the headrail to

the mounting bracket with the #10 x 5/8" screws

provided.

Make sure the pilaster is plumb

and that the spacing between

the pilasters for the doors is the

correct dimension. On the back

of each pilaster (starting with the

first pilaster), drill a Ø7/32" hole

through one face of the headrail

only.

Using this hole as a template,

drill a Ø9/64" pilot hole into the

pilaster, 5/8" (16mm) deep.

Secure the headrail to the

back of each pilaster with the

#10 x 5/8" screws provided.

For open end applications, cut the headrail to the appropriate length (if

required). Attach the bracket to the wall at the correct height (see step B).

Attach another bracket to a pilaster with #10 x 5/8" screws at the correct height

(see view below). The headrail should be level with any adjacent headrail

and should be located directly over the panel. Position each headrail onto the

brackets and secure with required fasteners (see step C). Using a rubber mallet,

install the headrail end cap.