Installation Guide

ManualsBrandsBradley ManualsEmergency & Safety EquipmentBradley Wall Mounted Cord Operated Drench Shower with Horizontal Supply and Plastic Shower Head

P.O. Box 309, Menomonee Falls, WI USA 53052-0309

PHONE 800.BRADLEY (800.272.3539) FAX 262.251.5817

bradleycorp.com

Installation

215-148CO Rev. S; ECM 12-05-016E

Page 1 of 4 8/9/2012

S19-120G

Cord-Operated Drench Shower

Table of Contents

Pre-Installation Information ........................ 2

Installation Instructions ........................... 3

Assembly of Components ......................... 4

Parts List ...................................... 4

Model S19-120G is not ANSI compliant.

Summary of content (4 pages)

PAGE 1
Installation S19-120G Cord-Operated Drench Shower Table of Contents Pre-Installation Information . . . . . . . . . . . . . . . . . . . . . . . . Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . Assembly of Components . . . . . . . . . . . . . . . . . . . . . . . . . Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Model S19-120G is not ANSI compliant. 215-148CO Rev. S; ECM 12-05-016E © 2012 Bradley Page 1 of 4 8/9/2012 P.O.
PAGE 2
S19-120G Installation IMPORTANT Read this installation manual completely to ensure proper installation, then file it with the owner or maintenance department. Compliance and conformity to drain requirements and other local codes and ordinances is the responsibilityof the installer. Installation Packing List IS TH SIDE UP • • • • Separate parts from packaging and make sure all parts are accounted for before discarding any packaging material.
PAGE 3
S19-120G Installation Installation Supplies Required: 24" (610mm) • (3) 3⁄8” floor anchors and bolts 15¾" (400mm) • Tefon tape and pipe sealant • Piping to 1¼” NPT water supply inlet and to 1¼” NPT drain outlet on unit • Adequate supply pipe supports 4½" (114mm) • Min. 4” drain to accommodate 30 gallons per minute discharge for shower waste Ø 3.1" (78.7mm) • OPTIONAL: sign-mounting hardware Step 1: Assemble components 1. Assemble the components as shown on page 4.
PAGE 4
S19-120G Installation Assembly of Components 1" NPT Supply Inlet 1.2 1 1.1 1.3 1.5 1.4 1.21 2 3 6 5 10 9 4 NOTE: Use teflon tape only. 8 11 114-050 P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA TEL: 1-800-BRADLEY FAX: (262-251-5817) http://www.bradleycorp.com R P.O. Box 309, Menomonee Falls, WI 53051 TEST THIS UNIT EACH WEEK DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN. ESSAI HEBDOMADAIRE 7 Test-operate valve(s) each week and sign below. Report any malfunctions immediately.