Specification Sheet

© 2017 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539) [phone]
bradleycorp.com
Page 1 of 2 10/16/2017
This information is subject to change without notice.
Bradley_IndividualShowers_WS-1X-HN
• Ideal for Barrier-Free Shower Room
• Industry Unique Hinge Design for Quick and Easy Installation and Maintenance
• Completely Preassembled and Ready to Mount to a Wall
• Flexible Supply Connections
Specifications
Materials
Shower panel is type 300 Series stainless steel. All other exposed parts are stainless steel
or chrome-plated brass. Supply inlets are flexible stainless steel hoses.
Standard Equipment
Shower Panel
Shower panel is constructed of 18 gauge stainless steel. Top and bottom covers are riveted
onto shower panel.
Hinges
Stainless steel barrel hinges to mount shower to wall.
Valve Type as Selected
For more information on each valve type, please enter the model number in the search box
at www.bradleycorp.com.
Showerhead
Showerhead is chrome plated brass with 1.5 GPM (5.7 LPM) flow control, ball joint and
adjustable spray pattern control (B).
Hand Shower
Consisting of hand shower with on-off control, a 60" stainless steel flexible hose and post
style mounting bracket to hold to shower panel. Elevated in-line backflow preventer with
quick disconnect for flexible hose.
Diverter Valve
Lever handle operation for easy transfer of water flow between fixed showerhead and hand-
held shower spray.
Supply Inlets
Supply inlets are 24" flexible, stainless steel hoses with 1/2" NPT connections. Inlets are
accessible through back of shower or through knockouts in the top and bottom covers.
ADA Requirements
This shower complies with most, but not all, ADA dimensional
requirements. Check local codes prior to installation.
Standard Selections (Must select one from each category)
Showerhead Height (select one)
6'-0" Standard Height
5'-6" Juvenile Height
Valve Type (select one)
Hot/Tempered and Cold Supplies
EF Equa-Flo Pressure Balancing Valve
HD Equa-Flo HD Pressure Balancing Valve
TMV Thermostatic Mixing Valve
Single Tempered/Cold Supply
AST Air Pushbutton
SVL Single Compression Valve
TTPA TouchTime Pushbutton**
TTPB TouchTime Piezo Switch**
Showerhead Type
B Axis Showerhead w/ Ball Joint (Flow Rate = 1.5 GPM/5.7 LPM)
S15 Standard Showerhead (Flow Rate = 1.5 GPM/5.7 LPM)
S20 Standard Showerhead (Flow Rate = 2.0 GPM/7.6 LPM)
Optional Selections
Ball Joint Type†
LBJ Lockable Ball Joint
NONE No Ball Joint
Supply Stop Type (select one) (included with EF, HD and TMV valves)
ST Stops in Supplies for Valves
NONE No Supply Stops
Soap Type (select one)
SD Standard Soap Dish
NSD No Soap Dish
Slide Bar Type (select one)
SB 24" Slide Bar (currently available on WS-1X-HN model only)
BS 30" Slide Bar (currently available on WS-1X-HN model only)
NONE No Slide Bar
Slope Top Type (select one)
SL Sloped Top
NONE No Sloped Top
Shroud Type
SHV Vertical Shrouds (floor to ceiling height _______ft. _______in.)*
SHH Horizontal Shroud (per 3' section)*‡
NONE No Shroud
Hardware Type (select one)
SC Standard Screws
VS Vandal Resistant Screws
*Non-cancelable, non-returnable
**TTPA and TTPB valves require a low-voltage UL/CSA listed 120VAC/12VDC plug-in
adapter.
† Only available on S15 and S20 Showerheads.
‡ Submittal drawings required.
Verify all rough-in dimensions prior to installation.
Consult local and national codes: conformity and compliance to local and national codes
is the responsibility of the installer.
2.5 GPM showerhead flow rate does not meet California Energy Commission 20 CCR
T.20, Div. 2, 1601-1609.
WS-1X-HN
Individual Pivoting Barrier-Free Wall Shower
WS-1X-HN