Specification Sheet

S53-326, S53-327
Aerada
™
1000 Series Gooseneck Faucets with Infrared Control
© 2016 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539) [phone]
bradleycorp.com
Verify all rough-in dimensions prior to installation.
Consult local and national codes. Conformity and compliance to
local and national codes is the responsibility of the installer.
Page 1 of 2 3/28/2016
This information is subject to change without notice.
Bradley_Faucets_S53-326_327
• Reliable Infrared Activation
• Adjustable Operating Modes
• Vandal Resistant
• Above-Deck Water-Tight Electronics
• 6V Lithium Battery Operation (Battery Included)
• 12V AC Transformer Available (Not Included)
Standard Equipment
Infrared Sensor
The IR Sensor uses a twin-beam system to respond quickly when needed, and to
elminate false activations. The electronics can be adjusted between static mode
sensing the complete IR beam and dynamic mode sensing only hand motion.
Valve
The electronically activated solenoid valve provides reliable performance since
there are few moving parts and its operation is unaffected by most chemicals and
minerals found in municipal water supplies.
Flow Control/Rate
Operating range 20–80 PSI. The vandal-resistant aerator produces a .5 GPM
flow rate.
Faucet Body
Single-hole cast brass spout centershank mounting with optional 4" centerset
trim plate available.
Sanitary
No-touch operation reduces water/soap splatter and addresses the public's
increasing awareness and concern about communicable diseases.
Vandal Resistant
There are no surface-mounted controls to tempt vandals. The circuit board and
range adjustment control are housed in a water-resistant housing above the
deck. The sensor will automatically shut off water after 45 seconds (in factory
preset mode) if a vandal attempts constant operation.
Code Compliance and Certifications
CSA
The 1000 Series Gooseneck faucets are certified to meet CSA B125 test
standards for plumbing fixtures. The faucets are CSA approved in Canada and
the United States.
ASME A112.18.1
The 1000 Series Gooseneck Faucets are certified to meet the ASME A112.18.1
standard for plumbing fixtures.
ADA Compliance
The infrared sensor produces a broad detection zone that allows disabled users
to easily activate the faucet from either a front or side approach, thereby meeting
ADA guidelines provided by ANSI A117-1.
Models
Faucet Only:
 S53-326 AC Gooseneck IR Faucet Centershank
 S53-327 DC Gooseneck IR Faucet Centershank
Check Your Surroundings
Certain factors, such as intense direct sunlight, other infrared devices, or other
site conditions may interfere with the activation of infrared faucets. Contact your
Bradley Representative to discuss any application concerns.
Sample Specification
No-touch infrared faucet shall be (S53-326) Bradley Aerada™ 1000 Series
Gooseneck IR Faucet. All Electronics shall be above deck within watertight
enclosure. The faucet shall include a chrome-plated, forged brass body with
centershank mounting. Faucet shall be certified to CSA standards for both the
United States and Canada.
Optional Selections
Trim Plate:
 150-221 4" Chrome-plated trim plate
Transformer:
(options only used with S53-326 AC faucet, cannot be used on S53-327 DC Faucet)
 232-008 Plug-in Transformer 12V
 232-009 Hardwire Transformer 12V (1–8 Faucets)
Flow Control:
 269-1923 2.2 GPM Laminar Flow Control
(The 2.2 GPM flow control does not
meet California Energy Commission 20 CCR T.20, Div. 2, 1601-1609.)
Water Supply:
 S45-2760 TMA Navigator
®
Thermostatic Mixing Valve Pre-Pack with
Flexible Hoses and Stops
 S45-2731 TL Flexible Hose and Stop Pre-Pack
Drain Assembly:
 269-1839 D-ASSY, Drain, Strainer, and Tailpiece
C US
Certified to
NSF/ANSI 372
Standard product selections contained within this document are third
party CERTIFIED to NSF/ANSI 372 meeting the Lead-Free content
requirement. Any product configured with custom options will be
COMPLIANT with NSF/ANSI 372 meeting the Lead-Free content
requirement.