Installation Guide

11
Installation Aerada 1000/1100 Series
Bradley • 215-1628 Rev. C; ECN 16-02-002 9/1/2016
Care and Maintenance
The following are described in this section:
• Activating Cleaning Mode
• Replacing Battery
• Cleaning or Replacing Inlet Filter
• Adjusting Water Temperature (Internal
Mixer)
• Adjusting Hot Water Limiter (External
mixer)
• Cleaning or Replacing Aerator
1
Fully cover sensor with hand until water flow stops.
This takes approximately 5 seconds.
Activating Cleaning Mode
In order to set the cleaning mode, the faucet needs to
have been set once into the "Manual Setting" mode. See
"Manual Setting" instructions. When cleaning mode is
activated, the faucet will be inoperable for 90 seconds.
2
Remove hand. Cleaning Mode is now activated.
Replacing Battery
A traditional lavatory faucet is shown as an example.
These instructions apply to all DC models. Before
replacing the batter, be sure that:
• Battery is low (LED is lit)
• New 6 V Lithium battery (CR-P2) is required
1
Remove shut-off screw.
2
Remove mixer handle (for faucets with external
mixer only).
3
Remove housing vertically.
4
Remove used battery from battery holder and
recycle.
5
Insert new battery. The LED lights up for 1 second.
6
Mount housing vertically.