Installation Guide

7
Installation Aerada 1000/1100 Series
Bradley • 215-1628 Rev. C; ECN 16-02-002 9/1/2016
Setting Scrub Mode (60 seconds)
Setting scrub mode for 60 seconds will allow the faucet
to activate for 60 seconds from the last hand presence.
1
Enable "Manual Setting" Mode (see "Manual
Setting Mode" on page 5).
2
Fully cover sensor with hand. Water flow stops
after 5 seconds. Continue to hold on for another
three (3) additional water pulses.
3
Remove hand. Scrub Mode is now activated for
60 seconds.
Setting Scrub Mode (180 seconds)
Setting scrub mode for 180 seconds will allow the faucet
to activate for 180 seconds from the last hand presence.
1
Enable "Manual Setting" Mode (see "Manual
Setting Mode" on page 5).
2
Fully cover sensor with hand. Water flow stops
after 5 seconds. Continue to hold on for another
four (4) additional water pulses.
3
Remove hand. Scrub Mode is now activated for
180 seconds.
Sensor Range Adjustment
The detection distance of the sensor can be adjusted
between approximately 4 - 11 inches from the infrared
window.
1
Enable "Manual Setting" Mode (see "Manual
Setting Mode" on page 5).
2
Remove all items from the sink.
3
Fully cover sensor with hand. Water flow stops
after 5 seconds. Continue to hold on for five (5)
additional water pulses.
4
Remove hand.
5
Hold hand in the current detection area until
LED flashes. Then move hand to the desired
detection distance. When LED stays lit for two
(2) seconds, detection distance has been re-set
to new location.
Reset
All settings will be reset to default settings. The "Manual
Setting" Mode will be disabled.
To reset all settings to default, follow steps in "Enabling
Manual Setting Mode" but Step 5 needs to be done six (6)
times in a row.