Installation Guide

4
Aerada 900 Series Faucet Installation
2/6/2018 Bradley • 215-1680 Rev. E; ECN 17-02-005
Multi-Faucet Wiring
One plug-in adapter operates up to four
faucets at one time. Additional plug-in
adapter(s) are required for installations
with more than four faucets.
H
C
DO NOT SKIP THIS STEP!!!
This valve is NOT factory preset. Upon installation, the temperature of this valve must be checked and adjusted
to ensure delivery of a safe water temperature. Water in excess of 110°F (43°C) may cause scalding.
This step only applies for units equipped with a TMA Navigator Mixing Valve.
Adjust Temperature with Running Water
3
A
Loosen cap screw about 1/4" (4-6 turns)
and lift up cover (do not remove).
B
Using cover, turn cartridge gently until
desired water temperature is reached. Do
not turn past stops as this may damage
unit. Push cover down and tighten screw.
Test Unit
4
This step only applies for units equipped with a TMA Navigator Mixing Valve.
A
Shut the hot water inlet off by closing
hot water inlet valve. While the hot water
supply is turned off, check to make sure
the cold water flow is reduced. If the cold
water is reduced properly, reopen the hot
water supply.
B
Shut the cold water inlet off by closing
the cold water inlet valve. While the cold
water supply is off, check to make sure
that the hot water flow has shut down.
2-Way Splitter
(251-027A)
3-Way Splitter
(251-027B)
4-Way Splitter
(251-027)
14' Cable
Extension
(251-026)