User`s manual

8-2 BBP

85 Label Printer

User’s Manual

Printer Maintenance

Removing Power and Media from Printer

3. To remove media:

a. If engaged, swing media wiper [3a] to far right (when facing display).

b. Flip yellow memory cell flag [3b] up and out of yellow memory cell

sensor [3c].

c. Rotate media roll until leading edge is removed from feed slot [3d] and

media starts to rewind around supply roll.

d. While compressing media cone [3e] on left side of printer, grasp tape

spool and pull it toward you.

e. When media roll insert is free of yellow drive cone [3f], lift tape spool out

of printer.

4. To remove ribbon:

a. On ribbon roll, flip yellow memory cell flag [4a] up and out of yellow

memory sensor [4b].

b. Snap hook of memory cell flag into the ribbon cartridge case.

5. While compressing spring on left side of printer, grasp both sides of cartridge

case and pull it toward you, then lift cartridge out of printer.

3e, 3f