User`s manual

BBP

85 Label Printer

User’s Manual

8-5

Printer Maintenance

Cleaning the Printer

Cleaning the Sensors

The sensors located inside the printer may be covered with dust that results from

cutting the media. Sensor locations are shown in the figure.

Materials Required

• BBP31 Cleaning Kit (Cat # B31-CCT)

• Isopropyl Alcohol (99% recommended)

To clean the sensors:

1. If necessary, remove power and media from the printer (see “Removing

Power and Media from Printer” on page 8-1).

2. With a pre-moistened foam swab, gently wipe the surface of the media

sensors at the locations shown in the figure. Do not allow the alcohol to drip

from the swab.

Note: Clean the color sensor every 12,000 inches (30,480 cm) with a cotton

swab to prevent color detection errors. To view the cumulative inches printed,

select Menu>More Tools>Diagnostics>Info.

Cutter Home

Door Open

Die Cut & leading Edge

Tape Wiper

Smart Cell

Color Calibration

Eject Home

Printhead