User`s manual

2-4 BBP

85 Label Printer

User’s Manual

Unpacking and Setting up Printer

Setting up the Printer

Install or Change Supplies

The media and ribbon supply cartridges use a “smart cell” to define and track the

supply information. The system automatically recognizes the supply information

for the installed media and ribbon.

Note: The printer can be either on or off when changing supplies.

Install Ribbon and Media

This procedure assumes you are at the side of the printer, facing the media and

ribbon rolls.

Note: An illustrations on the inside of the cover shows how to install the tape and

ribbon. The two steps on the left refer to loading the ribbon. The four steps on the

right refer to loading the media (tape).

1. Press yellow cover release button and raise printer cover.

2. Place ribbon roll inserts over yellow drive cones on left, then right sides [2].

3. Snap yellow flag into yellow memory cell [3].