User`s manual

BBP

85 Label Printer

User’s Manual

2-7

Unpacking and Setting up Printer

Setting up the Printer

2. If engaged, swing media wiper [2] to far right (when facing display).

3. Flip yellow memory cell flag [3a] up and out of yellow memory cell

sensor [3b].

4. Rotate media roll until leading edge is removed from feed slot [4] and media

starts to rewind around supply roll.

5. While compressing media cone [5] on left side of printer, grasp media (tape)

spool and pull it toward you.

6. When media roll insert is free of yellow drive cone [6], lift tape spool out of

printer.

Remove Ribbon

1. Press yellow cover release button and raise printer cover.

2. On ribbon roll, flip yellow memory cell flag [2a] up and out of yellow memory

sensor [2b].

3. Snap hook of memory cell flag into the ribbon cartridge case.

4. While compressing spring on left side of printer, grasp both sides of cartridge

case and pull it toward you, then lift cartridge out of printer.

5, 6