User`s manual

2-10 BBP
®
85 Label Printer User’s Manual
System Power
Resetting the Printer
Powering Off the Printer
When the system is shut down, the display turns off and the system goes into a
low power consumption state but does not require a cold start to turn back on. In
this state, you can either touch the screen or press the power button to return the
system to the same state it was in before going into lower power consumption
mode.
Note: To completely shut down the printer, you must disconnect the system from
the power source.
To turn off printer power:
1. With the printer on, press .
2. If there are unsaved changes in the currently active file, you will be prompted
to save the current label file:
• To power off without saving the current label file, press No .
• To save the current label file, press
Yes . See “Save a Label File” on
page 6-1
for further instructions.
Resetting the Printer
Use this procedure to reset the printer (e.g., if the screen freezes).
To reset the printer:
1. Press and hold for at least 5 seconds. The system performs the
initialization process and starts the printer. Any data in the Editor at the time of
the reset will be lost.
2. When the Home page displays, you can continue with your label activities.