User manual

79
Routine Maintenance
Cleaning Schedule and Procedures
5/13/08 BBP81 User Manual Y882746
Cleaning Schedule and Procedures
Specific cleaning procedures are provided on the following pages. Table 14 shows the
recommended cleaning schedule. These intervals are intended as guidelines only. You may
have to clean more often, depending upon your application and media.
.
Clean the Exterior
You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a
mild detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.
Important • Brady is not responsible for damage caused by the use of cleaning fluids on this
printer.
Table 14 • Recommended Cleaning Schedule
Area Method Interval
Printhead Solvent* Direct Thermal Mode: After every roll of
media (or 500 feet of fanfold media).
Thermal Transfer Mode: After every roll of
ribbon or three rolls of media.
Platen roller Solvent*
Media sensors Air blow
Ribbon sensor Air blow
Media path Solvent*
Ribbon path Solvent*
Tear-off bar Solvent* Once a month.
* Brady recommends using Preventive Maintenance Kit. In place of this kit, you may use a clean cotton swab dipped in a
solution of isopropyl alcohol (minimum 90%) and deionized water (maximum 10%).