User Manual
Table Of Contents
- Table of Contents
- Introduction
- External View
- Power Source
- Media Cartridge
- Power On
- Keypad
- Menus
- Getting Started
- Formatting
- Serialization
- File Management
- Label Types
- Banner Portrait Label Type
- Banner Landscape Label Type
- Fixed Length
- Custom Length (Version 2.0 only)
- Vial
- WireMarker Label Type (BMP®21-PLUS and 2.0 Only)
- Terminal Block, Patch Panel (BMP®21-PLUS and 2.0 Only)
- Panel Residential (Version 2.0 Only)
- Flags (BMP®21-PLUS and 2.0 Only)
- Breaker Box (BMP®21-PLUS and 2.0 Only)
- Technical Support Numbers/On-line Help
- Troubleshooting
- Appendix A - Symbols
- Appendix B - Supported ASCII Characters for Barcodes
Power Source
Loading the Lithium Ion Battery Pack
10
BMP
®
21-PLUS/BMP
®
21-LAB User’s Manual
Remove Lithium Battery
1. Squeeze the finger tabs
located on both sides of the
battery compartment door,
then swing the battery
compartment door up and
out. (The door will come
off.)
2. Placing your thumb at the
base of the printer, use
your forefingers to gently
pull up on the raised
portion of the battery. This
releases the top of the
battery from the contacts.
3. Grasp the raised battery
and pull it up and out from
the bottom contact slots.