User Manual
Table Of Contents
- Table of Contents
- Introduction
- External View
- Power Source
- Media Cartridge
- Power On
- Keypad
- Menus
- Getting Started
- Formatting
- Serialization
- File Management
- Label Types
- Banner Portrait Label Type
- Banner Landscape Label Type
- Fixed Length
- Custom Length (Version 2.0 only)
- Vial
- WireMarker Label Type (BMP®21-PLUS and 2.0 Only)
- Terminal Block, Patch Panel (BMP®21-PLUS and 2.0 Only)
- Panel Residential (Version 2.0 Only)
- Flags (BMP®21-PLUS and 2.0 Only)
- Breaker Box (BMP®21-PLUS and 2.0 Only)
- Technical Support Numbers/On-line Help
- Troubleshooting
- Appendix A - Symbols
- Appendix B - Supported ASCII Characters for Barcodes
11
Power Source
AC Power Adapter
BMP
®
21-PLUS/BMP
®
21-LAB User’s Manual
AC Power Adapter
The printer can be powered by an AC/DC power adapter. The AC/DC power adapter can also
be used to recharge the BMP21-BATT battery pack outside of the printer.
WARNING
Use only the 9V DC, Brady AC/DC adapters, shown below, for supplying power to the
BMP
®
21-PLUS/BMP
®
21-LAB Label Printer.
Attaching the Adapter
The printer can be powered through a designated AC power adapter.
Note: The lithium ion battery does NOT charge within the printer when using the AC
adapter.
1. Insert the round end of the optional adapter
cable into the plug-in port on the left side
of the printer.
2. Plug the other end of the cord into an
electrical outlet.