User Manual
Table Of Contents
- Table of Contents
- Introduction
- External View
- Power Source
- Media Cartridge
- Power On
- Keypad
- Menus
- Getting Started
- Formatting
- Serialization
- File Management
- Label Types
- Banner Portrait Label Type
- Banner Landscape Label Type
- Fixed Length
- Custom Length (Version 2.0 only)
- Vial
- WireMarker Label Type (BMP®21-PLUS and 2.0 Only)
- Terminal Block, Patch Panel (BMP®21-PLUS and 2.0 Only)
- Panel Residential (Version 2.0 Only)
- Flags (BMP®21-PLUS and 2.0 Only)
- Breaker Box (BMP®21-PLUS and 2.0 Only)
- Technical Support Numbers/On-line Help
- Troubleshooting
- Appendix A - Symbols
- Appendix B - Supported ASCII Characters for Barcodes
31
Menus
Units
BMP
®
21-PLUS/BMP
®
21-LAB User’s Manual
Units
The Units setting is used to configure label parameters for the printer. The units are:
• Inches
• Millimeters
Once configured, you do not have to indicate “inches” or “millimeters” (or their globally
accepted abbreviations or marks) when entering numbers in data fields. Likewise, in any scale
or range of measurement field (as found under Label Type), the range of measurements will
automatically configure to the units selected in the Menu function.
To set the default units:
1. Press MENU .
2. Navigate to Units, then press Enter .
3. Navigate to the desired units of measure, then press Enter .