User Manual
Table Of Contents
- Table of Contents
- Introduction
- External View
- Power Source
- Media Cartridge
- Power On
- Keypad
- Menus
- Getting Started
- Formatting
- Serialization
- File Management
- Label Types
- Banner Portrait Label Type
- Banner Landscape Label Type
- Fixed Length
- Custom Length (Version 2.0 only)
- Vial
- WireMarker Label Type (BMP®21-PLUS and 2.0 Only)
- Terminal Block, Patch Panel (BMP®21-PLUS and 2.0 Only)
- Panel Residential (Version 2.0 Only)
- Flags (BMP®21-PLUS and 2.0 Only)
- Breaker Box (BMP®21-PLUS and 2.0 Only)
- Technical Support Numbers/On-line Help
- Troubleshooting
- Appendix A - Symbols
- Appendix B - Supported ASCII Characters for Barcodes
Menus
Cut Mode
32
BMP
®
21-PLUS/BMP
®
21-LAB User’s Manual
Cut Mode
Set the Cut Mode default to determine when the printer should pause for cutting. There are two
modes to choose from:
• Cut Between Labels
• Cut at End of Job
In a multiprint job (serialized label, terminal block, breaker box, etc.) cut mode determines if
the printer should pause between each label for cutting the individual labels. If you select Cut
at End of Job, all labels in a serialized sequence, or all labels for each listed block in a terminal
or breaker box label type, will print out as one long string, pausing for cutting only after the
last label has been printed.
To set the Cut Mode:
1. Press MENU .
2. Navigate to Cut Mode, then press Enter .
3. Navigate to the desired cut mode, then press Enter .