User Manual
Table Of Contents
- Table of Contents
- Introduction
- External View
- Power Source
- Media Cartridge
- Power On
- Keypad
- Menus
- Getting Started
- Formatting
- Serialization
- File Management
- Label Types
- Banner Portrait Label Type
- Banner Landscape Label Type
- Fixed Length
- Custom Length (Version 2.0 only)
- Vial
- WireMarker Label Type (BMP®21-PLUS and 2.0 Only)
- Terminal Block, Patch Panel (BMP®21-PLUS and 2.0 Only)
- Panel Residential (Version 2.0 Only)
- Flags (BMP®21-PLUS and 2.0 Only)
- Breaker Box (BMP®21-PLUS and 2.0 Only)
- Technical Support Numbers/On-line Help
- Troubleshooting
- Appendix A - Symbols
- Appendix B - Supported ASCII Characters for Barcodes
68
Flags (BMP®21-PLUS and 2.0 Only)
Selecting a Label Type
BMP
®
21-PLUS/BMP
®
21-LAB User’s Manual
Flags (BMP
®
21-PLUS and 2.0 Only)
A Flag label wraps around a wire or cable, with the ends joined together to form a flag. The
Flag label type is designed to work with any media except SelfLam or Permasleeve.
To use a Flag label type:
1. Press LABEL TYPE .
2. Navigate to Flag and press Enter .
Data fields display requesting additional information.
3. In the Flag Length: field, enter the total length of the flag (as it exists before being
wrapped around a wire or cable).
4. In the Cable Diameter: field, enter the diameter measurement of the cable to which the
flag will be applied.
The range for the cable diameter is 0.25 inches (6.35mm) to 8 inches (203.2mm). By entering
the diameter of the wire or cable, the system automatically calculates an additional length of
label to allow complete wrap of the wire/cable with additional label material left for the flag.
Flag data fields Flag label on print out