Operator`s manual

21
Route the Label Backing back to and around the Media Rewind Hub, as
shown.
Insert the edge of the Label Backing into the Slot on the Rewind Hub and
then insert the Media Retainer, into the Slot on the Rewind Hub. Rotate the
Rewind Hub to remove any slack in the Label Backing.
)
After loading, close the Access Cover and then push the FEED key to
secure the backing material.
Note: To print on-demand, load the media as described above, and enable
the Present Sensor as detailed in Section 4.1.3.
Removal:
Grasp the used backing on the Media Rewind Hub, and while gently pulling
out on the hub, compress the hub and pull off the backing.