Operator`s manual

55
Step Operator Action Displayed Message Comment
10 Place the label (and
backing) under the Sensor
Eye Mark.
Press any key to continue.
Calculates the
parameter
settings for the
‘Paper’ value.
‘yyy’ is a
numerical value
representing the
current sensor
reading.
11 Depending upon the
‘Sensor Type’ selection,
observe the display for the
calibration message.
-OR-
-OR-
See
‘Calibration
Problems’
(listed below)
for other
possible
messages.
12 Exit upon successful
calibration: press the
key to back out
of the menu tree, when
prompted to save the
settings press the
key to return to the Main
Menu.
After saving the
settings, press
and hold the
FEED key,
approximately
4 seconds, to
calibrate the
label position.