Operator`s manual

Downloading: Using the DOS copy command (where ‘filename’ is the

program to download, e.g., 4206pa10_102.zs), enter the following:

copy filename lpt1:

Note: Printer Key hardware and software compatibility must at a minimum

level to accept the file download. In the example above, the hardware

compatibility level must be ‘pa’, while the software compatibility

level must be ‘10’ or higher; see Section 4.1.4, ‘Configuration Level’

for details.

After downloading starts, the following information will be displayed:

Displayed Message Comment(s)

The printer is receiving the new download image

(program).

Then:

The program has been successfully received. The

printer has verified it and is now erasing Flash

memory. At this point the previous software

program has been deleted from Flash memory.

And finally:

The printer is writing the new program into Flash

memory.

Upon completion, the printer will automatically reset and the new application

will begin running; however, before continuing the printer must be re-calibrated;

see Section 5.3.

Errors during downloading: If an error occurs during the download, the

process is aborted. If this process did not reach ‘Erasing Flash’, the previous

program is left intact; otherwise, a successful download must be completed

before the printer is operable again. The following is list of possible download

error messages.

(Continued next page)