Quick Start Guide

Quick Start Guide
12
Figure 8, Alignment Guides
5. Thread the material under the ribbon carrier, under the guides
(Figure 8, 2) and forward through the slot in the front cover.
6. Turn the green dial on the left (Figure 8, 1) to adjust the guides so they
just snug up against the labels. Do not tighten the guides enough to crimp
the labels.
7. Apply thumb pressure to the close points on both sides of the ribbon
carrier until it latches securely in place. Once the ribbon carrier is latched
in place, raise the front panel and snap into the closed position.
8. Close the printer cover (Figure 1, 4).
1
2