User guide

LOCKOUT-PRO
TM
ENTERPRISE User Guide 7- 15
To add a lockout step to either default list:
1. In the Set Defaults window and select Lockout Steps.
2. In the Application or Lockout Release Steps section, click New.
3. In the Add/Edit Lockout Application -or- Release Steps window, enter the short version of the step
in the Name box.
4. In the Text box, enter the full text of the step as you want it to display on the procedure.
5. Click OK to add the step. The short version of the step you entered in the Name box will be added
to the list of steps in the Set Defaults window and the box next to it will be checked to display
automatically on the procedure.
Note: If you do not want the new step to display automatically on the procedure, click in
the checkbox in front of it to remove the check.
6. In the Set Defaults window, click OK to save your changes or Cancel to discard them.
To modify a lockout step on either default list:
1. In the Set Defaults window and select Lockout Steps.
2. In the Application or Lockout Release Steps section, click the step you want to edit, then click Edit.
3. In the Add/Edit Lockout Application -or- Release Steps window, enter your changes to either or
both the short version of the step (in the Name box) or the long version (in the Text box).
4. Click OK to save the changes and return to the Set Defaults window.
5. Click OK to save your changes or Cancel to discard them.
To remove a lockout step from either default list:
1. In the Set Defaults window and select Lockout Steps.
2. In the Application or Lockout Release Steps section, click to highlight the step you want to remove.
3. With the step highlighted, click Remove.
Note: If you accidentally remove a step, click Cancel on the Set Defaults window. The
window will close and when you return, the step will be restored to the list.
4. In the Set Defaults window, click OK to save your changes or Cancel to discard them.
Changing which Lockout Steps Display Automatically
When you are creating a procedure, the lockout application and release steps on the default list will
either display automatically on the procedure, or will show up in a list from which you can select. You
also determine which will happen by setting those defaults.
To indicate the steps to display automatically by default:
1. In the Set Defaults window, select Lockout Steps.
2. In the Application or Lockout Release Steps section:
• Click to display a checkmark in empty boxes in front the steps you want to be added
automatically to procedures.
• Click to remove the checkmark from any boxes of steps you
do not want to be added
automatically.
3. In the Set Defaults window, click OK to save your changes or Cancel to discard them.