Printer User Manual

29Printer-Applicator-System PAM 3000

Loading Labels

1. Place the label roll (1) onto the prepared media supply hub (4) and slide it down against the

wind plate (3). The solid line represents the feed path of outside-rolled labels, the broken

line of inside-rolled labels.

2. Put the flange (5) on the supply hub (4), slide it down against the label roll (1) and fix it at

the supply hub by tightening the knurled knob (2).

3. Slide the media guide (11) outwards as far as possible.

4. Unlock the transport locking roller (7) by pressing the knurled knob (8) downwards.

5. Unroll a length of label stock from the media roll and feed it first to the printhead (9) as

shown in figure 7b.

It is particularly important to ensure that the media strip slides properly through the fittings

of the photocell assembly (10).

6. Feed the label stock out of the side of the printer until there is enough material to reach the

internal rewinder.

7. Take off all labels from the outstanding liner, and feed the liner as shown in figure 7b to the

internal rewinder (12).

8. Slide the media strip under the rewinder clamps (6) to the wind plate. Hold the rewinder

and turn the knurled knob (13) clockwise. That way the label strip will be fixed at the

rewinder.

9. Turn the rewinder (12) clockwise for tightening the label strip.

10. Press the knurled knob (8) upwards to close the transport system.

11. Slide down the guide (11) against the upper edge of the label strip.

Fig. 7b Media loading

78910 131211