Specifications

10 Printer-Applicator-System PAM 3000
Fig. 7 Preparation of the label supply hub
PAM 3000 is equipped with a rotating label supply hub, which is able to take up rolls with
a core diameter of 76 mm.
To take up these label rolls it is necessary to mount two adapters (3) onto the supply
hub :
Media Loading
Preparation of the Label Supply Hub
4
3
3
112
2
3
1
Loading Labels
Fig. 8 Label loading
 Put the first adapter (3) onto the supply hub (2)
and slide it to the wind plate (4) until it blocks.
Tighten the knurled srew (1).
 Put the second adapter onto the supply hub (2)
and slide it against the wind plate until the
distance between the outer edge of the adapter
and the wind plate (4) is a little less than the
width of the label roll.
Tighten the knurled screw (1).
1. Place the label roll (1) onto the prepared media supply hub (4) and slide it down against
the wind plate (3). The solid line represents the feed path of outside-rolled labels, the
broken line of inside-rolled labels.
2. Put the flange (5) on the supply hub (4), slide it down against the label roll (1) and fix it
at the supply hub by tightening the knurled knob (2).
3. Slide the media guide (11) outwards as far as possible.
4. Unlock the transport locking roller (7) by pressing the knurled knob (8) downwards.
5
6
4
78 910 11 12 13