Install Instructions

Factory Setting
Switch Default Options Comments
5
Heat Pump Systems (cont.)
NOTES - Heat Pump Systems
[1]Ifbatteriesareinstalledthe24VoltACcommonconnectionisoptional.
[2]SelectOforcoolactiveor Bforheatactive.
[3]InstallaeldsuppliedjumperbetweentheW2 and Eterminalsif
 thereisnoseparateemergencyheatrelayinstalled.
Provide disconnect and overload protection as required.
 CONV/HP CONV
 F/C F
 HE/HG HG
Set Installer Switches
4
 CONV Selectforconventionalsystems
 HP Selectforheatpumpsystems
 F Selectforfahrenheittemperaturescale
 C Selectforcelsiustemperaturescale
 HG Selectforgasheat
 HE Selectforelectricheat
Attach Thermostat to Sub-Base
5
1.Lineupthethermostatbodywiththesub-base.
2.Carefullypushthethermostatbodyagainstthesub-baseuntilitsnaps
 intoplace.
3.Insertquickreferencecardintoslotontopofthermostat.
NOTE: Installer switches are located on the back of the thermostat. The
reset button must be pressed after making any changes to these switches.
UP UP