Operating instructions

ER910/920 and ER910/920 AF Event Monitor
19
Service and Maintenance
Cleaning
Remove the batteries before cleaning the recorder. Clean the battery
terminals with a soft dry cloth. Dampen a soft cloth with mild detergent
and water to clean the recorder, lead wires, and belt clip.
Remove any adhesives from the patient lead wires with an adhesive tape
remover solution or swab. Use a mild disinfectant. Do not use alcohol
or acetone on the lead wires since they could stiffen and the insulating
plastic could crack.
Service
If there is a problem with the Monitor, review the problem descriptions
and solutions listed on the next page. If additional assistance is required
contact customer support via phone, Fax or E-mail listed below. Call
customer support before returning a Monitor to make shipping
arrangements.
A. Note there isn’t any preventative inspection or maintenance that
can be performed by the end user.
Service Items and Accessories
Description Part Number
Patient lead, 1 channel, shielded 350-0173-09
Patient lead, 2 channel, shielded 350-0173-10
Monitor belt clip / Holster 100-1764-002
Necklace 350-0180-00
Operator manual 600-0606-00
AAA I.E.C. LR03 Alkaline Battery 200-2492-001
ER910/920 and ER910/920 AF Event Monitor
20
Equipment Symbols
Symbol Description
Type B Applied Part
Consult manual.
SN
Serial Number
0086
Complies with the Medical Device Directive of the
European Union.
Waste Electrical and Electronic Equipment (WEEE)
It is the responsibility of the end user to dispose of
this equipment at a designated collection point for
recycling.
Date of Manufacture
Manufacturer:
Braemar, Inc.
1285 Corporate Center Drive, Suite 150
Eagan, MN 55121 USA
Phone: [phone]
651.286.8620
Fax: [phone]
E-mail: [e-mail]
Web: http://www.braemarinc.com
Contact Braemar for further technical information.
Authorized European Rep:
QNET BV
Hommerterweg 286
6436 AM Amstenrade
The Netherlands