Hardware manual

Software Configuration PCI VELOCITY / OPTO ISO RS422/485
Chapter 3 Page 22
Configuring Ports In Microsoft Windows NT 4.0.
Microsoft Windows NT Provides built in support for 255
standard serial ports. To setup your PCI RS422/485 serial card you
should follow these steps. Please note that to change any kind of
hardware configuration under Windows NT you must be logged in
as a user with Administrator level privileges, if you do not have
these please contact your system administrator.
Software Installation.
Insert the PCI Velocity RS422/485 into your PC, as
described in chapter 2, and restart. Place the supplied floppy disk
titled "Serial Solutions for Windows NT" in a suitable drive and
from the Start Menu choose Run and enter a:\setup (where a:
is the path to the floppy drive with the installation disk).
• InstallShield will then install the driver software automatically -
it will then copy the necessary files and start itself. This
automatically detects your new PCI serial card(s) and does not
require any further system restarting.