User Manual

INSTALL A T ION(INSTR U C TIONS(
6503 Instructions 2-4-14.Doc Page 8 of 8
55. Reassemble all previously removed parts.
56. If you connected the camera to a factory 8.4”
touch screen, and the vehicle has not been
reprogrammed to “enable” the camera, have a
Chrysler/Dodge dealer program the vehicle as
follows:
Dealer Programming Instructions
PARK VIEW REAR BACK-UP CAMERA
VEHICLE CONFIGURATION
Vehicle VIN must be updated with the sales code of the
added accessory in order to enable system functionality.
Using the DealerCONNECT website and the scan tool,
complete the procedure below:
A. Log on to https://dealerconnect.chrysler.com.
B. In the “Vehicle Option” screen under “Global Claims
System” category in the “Service” tab, enter the
VIN and add the following sales code: XAC (PARK
VIEW REAR BACK-UP CAMERA) as a “Dealer
Installed Option.”
C. Confirm that the new sales code has been
successfully added to the VIN. With the scan tool
connected to both the internet (via Ethernet port or
wireless connection) and the vehicle, follow the
steps below:
D. Using the scan tool select the VEHICLE
PREPARATION and then select RESTORE VEHICLE
CONFIGURATION.
E. Follow the step by step instructions on the scan
tool to complete the Park View Rear Back-Up
Camera vehicle configuration.
57. Start vehicle and shift into Reverse in order to check
that all connections were made properly. If all of the
connections are correct you will see the camera
image displayed on your factory 8.4” touch screen.
58. Reassemble all previously removed parts.