User Manual

INSTALLATION INSTRUCTIONS
1009-9000-00 4 of 18
9 August 2011
If your vehicle IS equipped with a uConnect and/or auto-dimming mirror follow step 10.
If your vehicle IS NOT equipped with uConnect and/or auto-dimming mirror, skip this
step and continue on to step 11.
10. For vehicles equipped with an auto dimming mirror or an uConnect mirror, wire the supplied
interior harness to the existing headliner harness using a soldering iron by following the next five
steps (a, b, c, d, e) and diagrams A and B on the following two pages. (Note: Tape the three
wires at the chassis end of the interior harness back using electrical tape, as they will not be
used in this installation process.)
a. Splice the black ground wire from the interior harness to the black/light green wire from
the existing mirror harness. Cover the connection with electrical tape or heat shrink.
b. Splice the green reverse wire from the interior harness to the white/light green wire from
the existing mirror harness. Cover the connection with electrical tape or heat shrink.
c. Splice the pink ignition wire from the interior harness to the pink/light green wire from
the existing mirror harness. Cover the connection with electrical tape or heat shrink.
d. Splice the orange wire from the interior harness to the tan/orange wire from the existing
mirror harness. Cover the connection with electrical tape or heat shrink.
e. Splice the white wire from the interior harness to the tan/white wire from the existing
mirror harness. Cover the connection with electrical tape or heat shrink.
For vehicles equipped with uConnect, wire the microphone harness (supplied separately) to the
existing headliner harness using a soldering iron by following the next three steps (f, g, h) and
diagrams A and B on the following two pages.
f. Splice the yellow open wire from the microphone harness to the dark blue wire from the
existing mirror harness. Cover the connection with electrical tape or heat shrink.
g. Splice the black ground wire from the microphone harness to the black/light green wire
from the existing mirror harness. Cover the connection with electrical tape or heat shrink.
h. Splice the blue 12V positive wire from the microphone harness to the dark green/yellow
wire from the existing mirror harness. Cover the connection with electrical tape or heat
shrink.