Owner's Manual
Connect the RED wire
of
the
power
harness to an Ignition controlled
power
source (it is recommended
to trim cable to appropriate length).
5)
Programming:
(It is important that the device be programmed in the vehicle on a flat surface with
NOTHING
in front
of
the vehicle
for a minimum
of
4 feet).
•
•
•
•
•
•
A- Slide
power
switch
on
Buzzer to Hi position
B-
Aim
sensor about 5 to 10 degrees higher than horizonta 1
C-
Tum
Ignition switch to Run
po
sition (Sys
tem
will emit a series
of
beeps)
D-
Place
box
on
either
3"
or
4"
side epending
on
how high curbs are in
your
local area at a distance
of
20" from the front
of
the vehicle.
E-
Rotate sensor down until it is pointi
ng
at the top edge
of
the front
of
the
box
(the sensor has a pencil
beam
IR
line
of
sight and so it
must
be aimed properly).
F-
Press the Program switch and the unit will beep 2 times followed
by
a constant tone
(if
this did not
happen return to step E and possibly aim sens
or
slightly lower then repeat step F).
G-
Raise
box
straight up and as soon as the sensor no longer detects the
box
the solid tone will stop
(this will confirm that the sensor is aimed properly.
If
the sensor continues to emit a tone with the
box
lifted the sensor is aimed too low
and
is picki
ng
up
the road,
if
so repeat steps E & F and retry step G).
H-
If
the distance is acceptable and the height is accurate then simply
tum
Ignition switch
Off
and the
distance will now be programmed in
(if
you prefer a different distance then place the
box
at the desired
distance
and
redo all steps starting with step D).
6)
Pre-delivery
testing:
• Tighten sensor
to
screw using supplied Allen wrench to insure that the sensor will not move during
normal operation.
Plal:e box iu fronl
of
vehicle ai a disianl:e ui
3G
''
Tum
Ignition On (unit will beep to confirm
power
up)
• Slide
box
toward vehicle until 3 beeps are heard from Buzzer.
Measure distance from box to vehicle and
t
~
e
distance and height should
be
as they were
when
programmed.
7) Use,
Care
and
Maintenance:
•
•
When
the vehicle is turned
ON
you
will hear a series
of
beeps to notify that the device is up and
running
Simply drive up to the curb at a slow speed (the device is intended for curbs that are vertical to the
parking space, curbs that are at an angle
wi
ll
not
be detected properly), and once the curb is within
programmed distance the device will beep to notify you to stop.
The device will shut down automatically when the ignition key is turned OFF .
It
is recommended that every time the oil is changed on the vehicle the sensor should be inspected for
proper angle
of
adjustment and to insure that the sensor screw has
not
come loose.
At
every car wash the sensor should
be
wiped down and any debris that are obstructing the lens be
removed (the sensor is relies
on
line
of
sight and so any build up will affect its performance).
BMW
3 Series
Toyota Prius
Cadillac CTS
220
East
Huron
St
Suite
235
Ann
Arbor,
MI
48104
www.brandmotion.com
2
Tel
734-619-1250
Fax
480-247-5999