Instruction Manual

!
"#$%&''&%"(#!"#$%)*+%"(#$!
1010 Instructions 9-30-14.doc
7 of 8
Route & Secure Chassis Harness
48. Route supplied Chassis Harness along existing
chassis harness toward rear of vehicle, staying clear
of body mounts. (Figure 28)
Figure 28
49. Connect supplied Chassis Harness to Tailgate Handle
Camera harness.
50. Secure supplied Chassis Harness along the existing
Chassis Harness using Wire Ties every 200mm
(approximately 8”). Note: Depending on vehicle
wheelbase there may be excess length in the
Chassis Harness. Loop, and secure with Wire Ties,
any excess harness length along the Body Frame
away from Mechanical areas.
51. Reconnect negative battery terminal. Tighten
negative cable nut to 5 N!m (44 lb in).
52. Test system functionality: start vehicle, apply brake,
and shift into Reverse. The camera image should
appear in the Mirror display.
53. Re-install all previously removed trim.
Mirror Harness Connector Pinouts
WIRE
COLOR
FUNCTION
16-PIN
CONNECTOR PIN #
10-PIN
CONNECTOR PIN #
N/A N/A 1 - 4 –
Gray Auto Dimming (+) 5 9
White Video (+) 6 –
Brown Video (–) 7 –
Black Ground 8 5
Dark Green Reverse Signal 12V+ 9 1
N/A N/A 10 10
Purple OnStar Keypad Output 11 3
Dark Blue OnStar Keypad Power 12 4
Pink Ignition Controlled 12V+ 13 2 (Red & Pink)
Yellow OnStar LED Green Signal 14 6
Orange OnStar LED Red Signal 15 7
Red
Auto Dimming (–) 16 8
16-pin Mirror Connector 10-pin Mirror Harness Connector
\
Note: 16-pin cavities
are numbered on
the back side of the
mirror connector.
Additionally,
Brandmotion
identifies Cavity 1
with a white mark.