Installation Guide

ManualsBrandsBrandmotion ManualsCar Audio & Video9002-7803V2

Table Of Contents

INSTALLATION INSTRUCTIONS

Universal Two-camera Trailer Vision System With 7”

Monitor

(Kit # 9002-7803V2)

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in the Kit:

Tools & Supplies Needed:

2 10m 4pin Connector Cable

2 20m 4pin Connector Cable

2 Connector mounting brackets

2 IR Cameras

2 Vehicle Mounted Dual Connectors

1 4pin Coiled Cable

Electrical tape

Zip ties

1” Hole Saw

3/16” Drill Bit

Digital Volt Meter

Screwdriver

Socket set

Wrench

Safety Precautions:

● Work in well ventilated area that is clear of obstructions.

● Secure vehicle with tire chucks in both front and rear of tires.

● Turn vehicle accessories OFF and ensure ignition key is in OFF position.

● Wear safety goggles and snug fitting clothes.

● Use tools only for their intended purpose and which are in good repair.

● Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color

instructions, as well as an installation video, please visit www.brandmotion.com

7803V2 Instructions 7/2/20

Page 1 of 7 KB

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Universal Two-camera Trailer Vision System With 7” Monitor (Kit # 9002-7803V2) Please read thoroughly before starting installation and check that kit contents are complete.
PAGE 2
INSTALLATION INSTRUCTIONS INSTALLATION: Rear trailer camera 1. Remove the 4 Allen screws that are located on the sides of the camera. Then remove the camera mounting bracket and visor. 2. Find an appropriate place to mount the backup camera. Line up the foot bracket to ensure that there is enough space to attach the camera to the body. 3. Attach the mounting foot using either self-tapping screws or a bolt and nut. 4. Use a 1” hole saw to drill a hole for the camera harness. 5.
PAGE 3
INSTALLATION INSTRUCTIONS 3. Make sure to use the male-ended plug for the trailer. (If the wrong one is used the plug will not be correct for the camera.) 4. Connect the 4-pin harness(s) to the trailer side plug.
PAGE 4
INSTALLATION INSTRUCTIONS 5. Then mount the plug’s 90º bracket to the trailer by using self-tapping screws and nuts and bolts depending on the trailer and location. 6. Attach the plug to the bracket by removing the 2 nuts and washers. Then attach the plug to the front of the bracket and secure with the original washers and nuts.
PAGE 5
INSTALLATION INSTRUCTIONS INSTALLATION: Vehicle harness and plug 1. Using the included template, drill a 1” hole facing the rear of the vehicles bumper to mount the vehicle plug. Look behind the bumper or bumper cover to make sure there is nothing on the backside of where the plug is going to go. 2. Using the same template, drill two 3/16” holes for the mounting screws. 3. Attach the plug to the vehicle by removing the 2 nuts and washers.
PAGE 6
INSTALLATION INSTRUCTIONS 4. There is an included aluminum bracket if you do not wish to drill into the exterior of the truck. This is the same style 90º bracket that is used for the trailer plug. 5. Connect the 10m (32 ft.) harness(s) to the 4-pin connector on the rear of the vehicle. Run the harness from the rear of the truck to the area where the monitor/display is located. INSTALLATION: Stand alone Monitor 1. Connect the 4pin harness to Video 1 on the monitor. 2.
PAGE 7
INSTALLATION INSTRUCTIONS 7803V2 Instructions 7/2/20 Page 7 of 7 KB
PAGE 8
3 Small holes: Use Ø16 drill bit Large holes: Use Ø1in drill bit