Installation Guide

INSTALLATION INSTRUCTIONS
INSTALLATION: Vehicle harness and plug
1. Using the included template, drill a 1” hole facing the rear of the vehicles bumper to mount the vehicle
plug. Look behind the bumper or bumper cover to make sure there is nothing on the backside of where
the plug is going to go.
2. Using the same template, drill two 3/16” holes for the mounting screws.
3. Attach the plug to the vehicle by removing the 2 nuts and washers. Then attach the plug to the
vehicle and secure with the original washers and nuts.
7803V2 Instructions 7/2/20
Page 5 of 7 KB