User Guide
! INSTALLATION!INSTRUCTIONS!
2632 Instructions 2-24-15.docx Page 1 of 3
Factory Display Camera Harness for Chrysler Town & Country, Dodge
Durango, Grand Caravan, & Ram Tradesman, Jeep Commander, Grand
Cherokee and Wrangler Factory Displays (Kit part number 9002-2632)
NOTE: Requires Chrysler/Dodge dealer to activate; see below
Applications: 2011 – current Chrysler Town & Country (RBZ, RHB, RER, REZ, RBZ, REW radios)
2011 – current Dodge Durango (RHR, RHB, RHZ, RHP radios)
2011 – current Dodge Grand Caravan (RBZ, RHB, RER, REZ, RBZ, REW radios)
2011 – current Dodge Ram Tradesman (RBZ, RHB, RER, REZ, RBZ, REW radios)
2008 – 2010 Jeep Commander (430, 730 radios)
2008 – current Jeep Grand Cherokee (430, 730, RHR, RHB, RB2, RHP radios)
2007 – current Jeep Wrangler (display radios)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Factory Display RCA Jumper Harness
Loose red and black wires (if needed)
White 22-pin Connector
These Instructions
Delphi Terminal Removal Tool #12094429 or
Small Flat Watch Repair Screwdriver
10mm Socket
Plastic Trim Removal Tool
Vehicle Service Manual (If needed)
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
IMPORTANT: Use of this camera with
the factory display requires activation
by a Chrysler/Dodge dealer. See below
for Dealer Programming Instructions.
If possible, have the dealer “enable”
the camera option prior to installation.