Manual

9651 Instructions 2-11-14.doc Page 2 of 2
Test Mirror
Set parking brake, start vehicle, and shift into Reverse. If image appears in the LCD display, all connections have
been made properly.
Temporary Monitor Manual Shut Down:
If while in reverse you require to turn OFF the camera monitor, simply press and release the POWER button on the
back side of the mirror. (Note: once reverse is disengaged the mirror will go back to normal operation and will turn
ON next time reverse is engaged).
NOTE 1: Mirror Voltage Requirements
The supplied Mirror must see a voltage of 12.5v DC or better on the Reverse trigger lead. In the event that the
signal is too low the signal quality may be affected drastically when the vehicle is running.
To correct low Reverse signal power, the voltage must be raised using a Single Pull Dual Throw Relay.
Relay Wiring:
30 To mirror Reverse trigger (Green lead)
85 Chassis Ground
86 Reverse trigger from vehicle (reverse lamp)
87 High current Ignition controlled power lead +
87a Not used
Connect the rest of the Mirror Harness wires as instructed above.
NOTE 2: For Ford vehicles only
If the vehicle has a separate display on the IP for the compass and it displays “– –“after the OE mirror is removed,
further steps are necessary in order for it to function again. You must supply two 9’ 20-gauge wires (recommended:
one red and one yellow). Splice the wires to the location from which you removed the vehicle’s mirror connector and
splice their opposite ends to the vehicle’s mirror connector that will be relocated along with the mirror circuit board.
For more details, refer to Section 6 of 1008-9520 kit instructions at www.brandmotion.com
HomeLink Set Up and Operation
1. Refer to supplied HomeLink “Programming and Information Guide.”
2. Keep HomeLink “Programming and Information Guide” in vehicle for future reference.
This HomeLink device is approved for use only in the United States and Canada.