Insatallation Guide

Extracting Toyota Venza Bluetooth Microphone From Mirror
After removing the original mirror from the vehicle place it on a clean workspace area
and perform the following steps.
1) Using a small flat head screwdriver slowly insert into microphone cap and pry up.
(Image A)
2) Disconnect the small Molex connector from the microphone PC board and remove
microphone. (Image B)
3) Extract the entire harness from the mirror (do not cut in half) (Image C)
4) Remove the overhead console and mount the microphone into the open area where the
microphone was in earlier models by using hot melt glue. (Images D & E)
5) Connect removed harness from mirror to microphone and vehicle harness and reinstall
overhead console.
Image A Image B Image C
Image D Image E