Owner's Manual


1210 Instructions 6-27-14.docx Page 8 of 12
Step 19: Route Plug of Charging Module
through 1/2" hole and place module in bin.
Flip tray over and insert the (2) 3/8” Pan
Head T-20 Torx Screws through tray into
module.
Step 20: From the topside insert the
remaining (2) 1/4" flat head screws through
the substrate and into the modules. Unscrew
the other (2) previously inserted ¼” flat
head screws and repeat steps 17 through 19.
Then replace the remove ¼” flat heads
screws.
Step 21: Install Non-Slip Freedom Charge
Mat to Wireless Charging Module. Place the 4
locator pins in corresponding holes.
Step 22: Firmly press Mat around LED.
Step 23: Proceed to Power Harness wiring
(Section 5).