Owner's Manual

Monitor Installation and Wiring

Roll Bar Mount

Vehicle Wiring

Camera Wiring

Part 1

Part 2

Part 3

1. Choose the proper size roll bar mounting ring.

2. Use supplied foam and apply to the inner ring of

the bracket.

3. Place mounting ring on desired location. A fair

amount of force might be necessary.

4. Attach the neck of the mounting bracket to

the mounting ring, and tighten the cross bolt.

a). Note: If there is still movement in monitor

bracket mount, lay 1 to 2 strips of electrical tape

between the roll bar and the bracket base.

1. Connect the RED to 12-volt accessory.

2. Connect the BLACK to ground.

3. Connect YELLOW to 12-volt constant power.

1. Connect the GREEN wire to select

parking.

2. Connect the White

3. The BLACK connector is for the power plug.

loop on the camera harness.

Vehicle Application:

Utility Task Vehicles

Part Number: SUTV-2010

Installation Instructions - UTV Camera System Page 4/5AR_12_23_20