Operation Manual

15
INSTRUCTIONS FOR THE USER
It is necessary that all the operations regarding the installation, adjustment and
adaptation to the type of gas available are carried out by qualified personnel, in
conformity with the regulations in force.
The specific instructions are described in the booklet section intended for the
installer.
USING THE BURNERS
The symbols silk-screen printed on the side of the
knob indicate the correspondence between the
knob and the burner.
Automatic start-up with valves
Turn the corresponding knob anticlockwise up
to the maximum position (large flame, fig. 1) and
press the knob.
Once the burner has
been started up, keep
the knob pressed for
about 6 seconds.
Using the burners
In order to obtain the
maximum yield without
wa ste of ga s , i t is
important that the diameter
of the pot is suitable for the burner potential (see
the following table), so as to avoid that the flame
goes out of the pot bottom (fig. 2).
Use the maximum capacity to quickly make the
liquids reach the boiling temperature, and the
reduced capacity to heat food or maintain boiling.
All of the operating positions must be chosen
between the maximum and the minimum ones,
never between the minimum position and the
closing point.
Use the maximum capacity to quickly make the
liquids reach the boiling temperature, and the
reduced capacity to heat food or maintain boiling.
All of the operating positions must be chosen
between the maximum and the minimum ones,
never between the minimum position and the
closing point.
The gas supply can be interrupted by turning the
knob clockwise up to the closing position.
If there is no power supply, it is possible to light the
burners with matches, setting the knob to the start-
up point (large flame, fig. 1).
BURNERS Power W Ø of pots
Auxiliary
1000 10 - 14 cm
Semi-rapid
1750 16 - 18 cm
Rapid
3000 20 - 22 cm
Triple crown
3800 24 - 26 cm
Notice
When the equipment is not working, always check -
that the knobs are in the closing position (see
fig.1).
If the flame should blow out accidentally, the safety -
valve will automatically stop the gas supply, after a
few seconds. To restore operation, set the knob to
the lighting point (large flame, fig. 1) and press.
While cooking with fat or oil, pay the utmost -
attention as these substances can catch fire when
overheated.
Do not use sprays near the appliance in operation. -
Do not place unstable or deformed pots on the -
burner, so as to prevent them from overturning or
overflowing.
Make sure that pot handles are placed properly. -
When the burner is started up, check that the -
flameis regular and, before taking pots away,
always lowerthe flame or put it out.
Fig.1
Fig.2