Cable Drum Machine Operation Manual BC2040 Used For: Sinks, Showers and Tub Drains (Not for roots) READ THIS OPERATION MANUAL CAREFULLY BEFORE USING THIS PRODUCT. FAILURE TO UNDERSTAND AND FOLLOW THE CONTENTS OF THIS MANUAL MAY RESULT IN ELECTRICAL SHOCK, FIRE, AND/OR SERIOUS PERSONAL INJURY OR DEATH. KEEP THESE INSTR UCTIONS IN A SAFE PLACE FOR FUTURE USE OR WHEN LOANING OR SELLING THE PRODUCT.
SAFETY SYMBOLS & SIGNAL WORD In this Operation Manual and on the product, safety symbols and signal words are used to communicate important safety information. This section is provided to improve understanding of these signal words and symbols. • This is the safety alert symbol. It is used to alert you to potential physical injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. ? ? CABLE DRUM MACHINE SAFETY ? Read all safety warnings and instructions.
WARNING indicates a hazardous situation that, if not avoided, could result in death or serious injury. Save all warnings and instructions for future reference. • The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery operated (cordless) power tool. • Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool.
• Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. • Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
Prepare the Work Area • Make sure the work area has satisfactory lighting. • Do not work in areas that have combustible liquids, dust or vapors that may ignite. The drain machine is not explosion resistant and can create sparks. • Do not work in any area until all the flamable sources have been identified and corrected. • Never place the machine in water. If necessary, remove the water from the work area prior to use. • Be sure the electrical outlet is properly grounded.
OPERATING INSTRUCTIONS Do not continue to force cable into the drain pipe. This can cause the cable to twist, buckle, kink or break. If your machine is not properly operating, do not use it until the machine is properly repaired. Do not allow the cable to twist, kink, buckle, become overstressed or stuck. If the cable begins to get stuck or buckle/twist, immediately remove your foot from the foot switch while firmly holding the cable with both hands.
Post-Operation Maintenance 4. Reinstall belt guard and wing nuts. 1. Drain water from drum. Your model is equipped with a drain hole in the cable drum. Water, sediment and debris can corrode cable – remove the drum from the machine (see “To Remove Drum from Frame” below) and place it face down to allow all the water to drip out. This should be done after every use. MACHINE MAINTENANCE Belt Installation 1. Remove wing nuts on the belt guard (pulley wheel cover) and remove the belt guard. 2.
Manufacturer assumes no responsibility for failure due to improper use. ©2019 Brasscraft Manufacturing Company, Novi, MI 48375-5331 U.S.A. All Rights Reserved. www.brasscraft.com Made in China to Brasscraft Mfg. Co. specifications. BrassCraft® brand is a trademark of Brasscraft Mfg. Co. El fabricante no asume ninguna responsabilidad si la uso no se hace de acuerdo al instructivo. Todos los Derechos Reservados. Hecho en China bajo las especificaciónes de Brasscraft Mfg. Co.
