How to Guide

www.brasscraft.com
Post-Operation Maintenance
1. Drain water from drum. Your model is equipped with
a drain hole in the cable drum. Water, sediment and
debris can corrode cable – remove the drum from the
machine (see “To Remove Drum from Frame” below)
and place it face down to allow all the water to drip
out. This should be done after every use.
MACHINE MAINTENANCE
To reduce the risk of electric shock, re, serious injury
or death, the motor switch should be OFF and machine
unplugged prior to performing any maintenance,
adjusting, or when cleaning this product.
Cables
• The metal cable should be thoroughly cleaned with
water and lubricated to prolong cable life and prevent
unpleasant odors and the damaging effects of sediment
and drain cleaning compounds. Cleaning and lubricating
should occur prior to storing the machine.
• Regularly inspect cables for damage. Replace cables
that are worn or kinked.
Lubrication
The cable will need to be lubricated after each use.
Storage
Store machine in a dry, safe, secured place, out of the
reach of children and people unfamiliar with this machine.
To Remove Drum from Frame
1. Remove wing nuts on the belt
guard (pulley wheel cover) and
remove the belt guard.
2. Remove the drive belt from the
drum by pressing down rmly on
the spring motor housing and
release the drive belt.
3. A release hook is situated
immediately behind the drum. Pull this hook upward and
pull the drum forward to remove it from the frame.
To Connect the Drum to the Frame
1. Place center of drum hub on drum
drive. Pull the release hook up to
securely push the drum on the frame.
2. Slide the belt under and over the
drum and onto the pulley wheel.
3. Push the motor housing
downward to locate the belt onto
the pulley wheel.
4. Reinstall belt guard and wing nuts.
Belt Installation
1. Remove wing nuts on the belt guard (pulley wheel
cover) and remove the belt guard.
2. Slide the belt under and over the drum and onto the
pulley wheel.
3. Push the motor housing downward to locate the belt
onto the pulley wheel.
4. Reinstall belt guard and wing nuts.
General maintenance and other tasks detailed in this
manual, such as the replacement of the cable or a
damaged belt guard can be done by a qualied owner.
Other servicing repairs, such as the replacement
of a defective motor switch, must only be done by
BrassCraft. Please contact BrassCraft Customer
Service at 877-272-7755.
When servicing, use only genuine BrassCraft parts or
contact customer service. Not using proper parts may
result in electric shock/serious injury or death.
Installing Replacement Cable
1. Ensure the motor switch is OFF and machine unplugged.
2. Loosen the thumbscrew and remove existing cable
from the machine.
3. Disconnect secured cable end from inside drum unit.
4. Carefully remove the new cable from the packaging.
The tension is likely built up and has potential to strike
the user.
5. Uncoil the new cable completely.
6. Carefully insert the cable into the drum and
reconnect the cable to the inside drum unit for a
counterclockwise insertion.
7. Once cable is secured in drum, continue to insert the
remaining cable counterclockwise until you reach the
slotted end. This part should remain on the outside of
the drum.
8. Finally, tighten the thumbscrew.
REPAIRING YOUR DRUM
MACHINE