Installation Guide

• DO NOT stretch the connector to make it t.

Connector must be long enough to allow the

appliance to be positioned at its farthest anticipated

connected distance from the gas supply without

stretching, twisting or bending smaller that a 1-1/2

internal diameter (diameter of a golf ball).

• DO NOT trap connector against sharp edges

or corners.

CAUTION: DO NOT kink, twist or bend connector sharply.

6. Turn manual shut-off valve on to allow gas to

enter system.

WARNING: DO NOT TURN ON APPLIANCE until all

connections have been leak tested!

WARNING: DO NOT USE matches, candles, open

ames or other sources of ignition to leak test

connections!

7. Test all connections with leak test solution provided,

or with clear soap and water solution; bubbles will

indicate a leak. If a leak is detected, turn off gas

supply before further tightening connections.Water

rinse and towel dry connector once test is complete.

8. Wait at least 10 minutes to be certain that all vapors

have dissipated. If leak test conrms connections do

not leak gas, and you do not smell any gas,

THEN light pilot(s) and turn on appliance.

Tools Needed for Installation:

• (2) 10” adjustable wrenches

• Pipe dope or gas pipe thread tape

• Leak detection solution

BrassCraft Mfg. , 39600 Orchard Hill Place Novi, Michigan 48375-5331

TOLL-FREE: 877.272.7755 FAX: 248.305.6011 www.brasscraft.com

325.01 11/11