Specification

Job Name Engineer / Architect
Job Location Wholesaler
Submittal Date Contractor
This specification and all information contained herein is the confidential and exclusive property of
BrassCraft Manufacturing, and shall not be disclosed to others without the written consent of BrassCraft.
This specification must be returned to BrassCraft if requested.
300.20 BWB25/28 Braided Water Heater Connectors REV 01/1111 2011 Brass-Craft Mfg.
Product Submittal Form
BWB25/28 .57” ID Braided Water Heater Connectors
Use: For use in exposed locations only to connect water heaters and other water connected devices to the
water supply. Not intended for use with recirculating water systems that produce continuous use
temperatures above 115° F. For those applications use BrassCraft’s CopperFlex series connectors.
Design Features:
 Superior corrosion resistance to harsh chemicals found in common household
cleaning and plumbing repair products
 Greater strength & flexibility. The patented polymer braid exhibits greater
elasticity than stainless steel braining, significantly increasing the flexibility of the
connector
 No kinking, No crimping. The polymer braided jacket is specially engineered to
bend freely without kinking or crimping the connector
 Won’t work harden even with repeated bending
 No dielectric union needed with installation as the braiding and rubber are
constructed of non-conductive materials
 Less torque to seal against the pliable Nitrile rubber washer, especially on rough
nipple surfaces
 Longer connector nuts allow a greater number of thread-to-thread contacts
and offer a better seal
 100% compliant to California and Vermont “low-lead” requirements
Operating Specifications:
Temperature: 40° to 140° F, intermittent to 180° F
Pressure: water pressures up to 125 psi maximum
MATERIAL SPECIFICATIONS
Inner Hose
EPDM rubber
Braiding
PVC coated polyester yarn
Barb
Compliant brass
Ferrule
C26000 brass
Nut
C36000 brass
Washer
Nitrile rubber
For Residential and Commercial Applications